buckeyestargazer's latest activity

Romex is bundled THHN. 10/2 would be dandy.

I wasn't sure if I should use 10AWG THHN or 10/2 romex, or even if those are the same thing. Basically, I know just enough to be dangerous.

10awg THHN is rated for 30A.

I have a travel trailer with 30A service and I'm adding a whole trailer Renogy 3000W inverter. The inverter has a dedicated AC terminal...

You may find stacking lugs on the shunt hard. I found dealing with thick wires with strong batteries much harder to manipulate than the...

Thanks. I think it will be three at most, and maybe two. And actually there might already be a bus bar in the trailer. I'll have to...

Yes you can, but if you have to stack more than a few lugs on the system side of the shunt, a bus bar may be more practical.

I am buying a new travel trailer that comes with a 200W solar panel and MPPT charge controller (along with the 30A 120v system and 12v...

You must have the inverter/charger. I just have the inverter, which does not have AC input for pass through.

What specific inverter do you have? I was planning to use an automatic transfer switch to feed the converter/charger from either the...

The renogy 12v 3000w inverter and the 12v 230A battery. The inverter is new and I could probably return it. The battery has a Daly 100A...

Alright, thanks for the info. I wasn't even thinking about adding batteries. I figured 230AH would be enough. I built this 4S battery...

Right, but you can buy a BMS that can supply 200A or 250A. I believe my battery is 1C so theoretically it could supply 230A(?). I'd...

I'm planning to add a whole RV inverter and could use a little help figuring parts of it out. I'm planning to use the Renogy 3000W...