Dooug's latest activity

Batteries to bus Bar(lynx) with equal length wires is the ideal set up. Better current sharing ability and will give you the option to...

Mine balanced up ok at the top, i did keep charging voltage low at first. Started at out 3.40 volts per cell and crept up over two weeks...

Instead of chasing a 40 amp mega fuse you could run a small sub fuse panel with AMI/midi fuses that go as low as 30 amps. Run the...

Would a cerbo/smart shunt/multiplus combo running dvcc shared voltage be the same as the V-sense wire? I think the shunt be the most...

I purchased a different branding of the same crimper to use for 1/0 lugs and it's ok. It pinched a little bit of the lug neck out on the...

Our dishwasher is ok, we only run it on opportune days. We feed it from a propane on demand heater which helps a lot. However, part way...

Yes, as long as your solar charge control input voltage limit is not breached. You could have 5 24v panel in series on a 150 volt...

There are a couple switch kits for high idle, tuner not required. Can also use an upfitter switch and resistor wired into the factory...

There is in inefficiency of going DC/AC/DC but there's also plenty of inefficiencies try to move 80+ amps of 12v DC to try and match the...

What model Orion and what size wiring to it? The eg4 charger should pull just under a 1000 watts depending on efficiency. So a decent...

48v alternators exist. Adding one to transit may be tricky.

Blues seas makes a 1000 amp bus bar, 12 5/16 posts on it 6 and 6. Could run 5 batteries up from the bottom and 3 pairs of inverter...