GXMnow's latest activity

Midea seems to make good stuff. I'll watch to see how your setup holds up. I also looked into the twin hose models, but ran into similar...

My original thought was to have the hot water line from the main water heater go to the inlet pipe on the electric one. They typically...

I have thought about that. Two of my bathrooms are at the far nd of the house from the 40 gallon gas water heater in the garage. I have...

I was out of town for work for nearly a full week. I was only a little closer to the Eclipse though. It was still only about 50% cover...

Here is my production graph from So Cal. Well out of the total coverage area. The power cut to about 50% on a totally cloud free sky.

Production is basically done for the day. It looks like I pushed about 2 KWHs from the DC system out to the grid. That made just enough...

We had 2 days of poor production, and my battery got down to 51 volts, I have it stop grid support at 50.5, so it was about as low as I...

PV solar power does not really work like that. The amount of power coming from the panels is constantly changing with the amount of...

I just found these on Amazon. They would probably be great for what we do under 100 volts...

Mine are over 20 years old. They are below the "Class 0" electricians gloves. Mine are probably rated to just 500 volts, but thy bend...

Here is the line I used for my DC breakers...

Not always. It is very possible for the inrush to fry the MOS FETs. And in many cases, when they fail, they can fail in a short...

Many of the "Server Rack" style battery units do have a pre charge circuit. If your battery has it, it will be clearly mentioned in the...

I am commenting here mainly to follow where this goes. I would like to add Arc Fault to my DC array at some point. It is not technically...

Lowest March ever... software was updated... 3 power cutover events from storms. IQ Gateway (Envoy): D7.3.621 → D8.2.127 IQ System...

I'm done. I am now ignoring this thread. You can't possibly be this bad at simple electronics and logic. I think you are just fucking...

The BMS you showed in post #106 is for 3S NMC cells. That won't work with LFP cells. NMC cells are 3.6 or 3.7 volts each and can charge...

We are now 2 weeks into the next billing month. Things are looking good, even with a few storms moving through. Here is what So Cal...

There should be a fuse between the charge controller and the battery. It should be the next standard fuse large than the charge...

Also get a BMS to connect to those cells. Without a BMS you are near certain to ruin those cells as well. Can you see links to Amazon...