Most reacted threads

Hi, Just setup my system: 15 420w Jinko Solar Panels 5kW Sunsynk Hybrid inverter Seplos Mason 48V 14.3kWh battery with 16 Grade A V3 LF280K EV BMS setup advice thanks to @houseofancients Has been supplying house for 8 days , all looks to be running fine - using Octopus agile tariff & daily...

Hi, Currently fitting my solar panels on shed roof. The solar panels are sitting 110mm off the roof. Question is when I am connecting the panels up Whats the best position for an mc4 connector. I was thinking of fastening them on the underside of the panel, in the channel. Any advice...

Hi, Had this fault pop up on my app this morning - F55 - DC_VoltHigh_Fault Looking at battery voltage it had shot up to 62.6V - Inverter is connected to SEPLOS Mason LF280K - BMS Over Voltage Protection is set at 56.80 - connected via CAN The alarm has now cleared - anyone else had...

Hi, I am very new to this so please bear with me I have purchased 15 x 420Wp Jinko panels & currently looking at Solis 6kW or Sunsynk 5kW inverter. With the 15 panels with Voc @ the coldest last year that equates to 41.81v equals 627 volts Max capacity on the 2 Hybrid Inverters I am looking at...

Hi, Hope you can help. Setup my Sunsynk 5kW with Seplos 280 aH with v3.0 bms Inverter came on, battery pack started charging, then for some unknown reason went into standby. But the inverter is still showing a 2kW pull from the grid, battery is showing a -2kW reading. BMS Studio is showing...

Hi, As title suggests I have assembled a Seplos battery pack with a v3 active balancer. Just waiting on cable to setup up BMS & a few cables for my Sunsynk 5kW inverter. I was recommended to use a Neey 4A Active balancer, this was before I realised I had one on the Seplos system I have...