Most reacted threads

Recently a bank of 24 Nesscap 3500F Supercapacitors was added to my system to assist with DC ripple and surge loads. Although a big investment, their performance and the preservation of battery longevity they provide is worth it, in my opinion. These capacitors will easily pass 1500 Amps and...

There is nothing I hate more than my Flooded Lead-Acid batteries, but I am committed to keeping the promise I made to myself that they would not be replaced until something Lithium Iron Phosphate or Sodium Ion becomes available with USA-manufactured cells. So, they remain in-place for now...

I have a pair of XW Pro 6848 in sync with the whole house on their load side. The desire is to power the loads with prioritized available DC, and use the grid to make up the difference when batteries fall below Grid-Support voltage. It is desired to have zero draw from the grid (AC1) when DC is...

Has anyone running a pair of XW Pro 6848 in Split-Phase Primary/Secondary noticed imbalance in load sharing between the two since installing Firmware v2.04? Under all circumstances in v1.xx firmware the loads would balance, on average, seamlessly between both inverters. Sometimes the bulk of...

In most cases I fanatically adhere to published specifications and setpoints per manufacture recommendation. I was curious if anyone else has run into the same caveat I have with U.S. Battery RE L16 XC2. These are FLA 3-cell 6v 112lbs. batteries in L16 form factor, rated 401Ah at a 20hr rate...

Dear Schneider, The ecosystem of available 48V devices continues to grow along with the likelihood of more things being connected to the DC bus of a Schneider Insight system. Please make a Xanbus configurable AUXILIARY SHUNT CONTROL INTERFACE for Insight so we can monitor and log DC power flow...