Does anyone have experience with SANY solar panels this seems to be a new manufacturing company they are producing N – type panels. I am looking to get SYMN144TBD 570W
Here is the support contacts for the DSSmonitor
This the developer company of the website
wanghuiqun@eybond.com
market@eybond.com
info@shinemonitor.com
to answer the question about the load, I am not planning on running the load through the voltage detector, that is why I am using a Power relay so the load is running through it and not running through the voltage detector
My system is not installed yet, so I have not gone that far in the calculations to see how much extra power I will have from the panels. I think you can control this by programming the voltage detector to turn on for a certain hours of the day. there are some videos on YouTube about how to do...
My plan is to use voltage detector like this, set it up to trigger the NO contacts when the batteries are full, then will connect these contacts to a mechanical power replay AZ2280 to provide power to the water heater.
https://www.azettler.com/pdfs/az2280.pdf
This setup is better than using the...
Have you tried to parallel your LV6548 with LV6548V? Is this possible? I have LV6548 and considering getting the V for the PV input but wanted to see if I run them in parallel as single phase.
https://generatorupgradesupply.com/products/remote-start-and-stop-complete
I found this online for Preditor generator, this will allow you to start the generator remotely, but I dont know how you will auto start it.
I came to the conclusion that using the voltage detector would be a better option than using the dry contacts, that way I have better control on when the dump load is triggered.
Thanks for the idea about the voltage detector.
I was going to either use the power supply from the battery ( 48V ) or the inverter output 120V with C and NC contacts to trigger a power relay. S here is what either would look like. I have seen online somone uses DC signal input for the dry contact.
Does anyone knows how the dry contact works on LV6548 or 6500EX. The manual says that it is 250VAC 3A. I dont know what this means, is this 250VAC supplied voltage by the dry contacts or do I need to supply the voltage to it from another source, for example the inverter output?
Can I run a...