Logic28's latest activity

Here is the answer: Look for off grid garage How to setup the Seplos BMS 10E. Works amazingly with the right settings.

A novel problem for me, today my seplos 200 based 48v 304A battery after reaching 100% SOC entered the single cell over voltage...

by com port do you mean RS485 or Can Bus Please?

I have the same brand (DAREN BMS) on my first 100A Odipie Battery pack and it is a nightmare to make it communicate to Victron GX. I...

Disconnect it from the battery for about 5 minutes. If your rs485 comes back, email seplos for a firmware update

Probably the oldest out there :)

What firmware version are you running please? I'm trying to familiarise with this subject and avoid falling in upgrades which are worst...

We were definitely working with my version, which is 10E.

are you sure he wasn't talking about the v3 version ? haven't seen this behavior in mine ( 10E)

According to the Seplos tech I dealt with, it only retrains if within 30% of current settings.

It's a 204-10E, thanks for your answer and, just as I assumed and in fact after a couple of hours on a slow 5A charger up to 58.4v it...

No warnings other than Victron shutting of the inverter when it receive the "erroneous" battery SOC. All battery cells torques checked...

I'm no expert, so take this with a grain of salt. Below is my understanding: 1. No. Factory defaults should be sufficient. 2. What's...

A few days ago I started my newly built 304A Battery managed by the Seplos 200 16s BMS and was trying to obtain a full charge and full...