Hey guys, I'm using 2 of the BluePower SP6548 SOLAR INVERTER and 6 of the EG4 (48V/100AH) LL Battery.
The inverters switches to the grid mode when the batteries runs out of power (0% SOC). How can I make my inverters switch to grid mode when the batteries are about 10% of charge?
Please see...
Signature solar only has Communication Hub for the LifePower4 batteries, not for the EG4 batteries.
My inverters doesn't support my EG4 battery protocol.
So I guess I'm stuck with what I have :(
Thank you for the help. I guess it was my fault for not checking before building my first solar...
Hi Guys,
I'm using 6 batteries EG4 batteries and 2 of the SP6548 inverters split phase. (attached manuals to this email)
I'm following the manual and using the ethernet cable, but I can't get to make them communicate with each other. I would like for the inverters to read Sate of Charge on...
I cleaned the panels today, and I was able to get 6KW MAX in full sunlight. Still missing 1.8KW according to the rating on the panels, but not sure if that's normal.
Hey guys, I have 2 of the BluePower SP6548 SOLAR INVERTER. I installed 20 panels of CS3N - 395MS.
On paper, each solar panel generates 395W with full direct sunlight. That means 7,900W in total. All panels are on the same roof at the same angle.
I have 2 inverters split phase, and at max...
Hello everyone,
My normal public electrical pole provides 240V 150A Single phase to my home. I just installed off-grid solar panels and I'm using 2 of the BluePower SP6548 SOLAR INVERTER.
Can I use my 2 inverters and provide power to my home using split-phase? (L1 and L2)
is this safe? Will I...
The inverters should be Synchronized. The 4 cables of communicated and current share are all connected.
the manual states that you can connect the inverters parallel or in multiple phases. Please see attached document.
But I don't want split-phases from my off-grid system. I want single-phase Electricity.
The normal Electricity that I get from the public utility pole is single-phase.
Please see attached document.
Hello Everyone,
I have 2 of the BluePower SP6548 SOLAR INVERTER. I'm getting Fault 72 and I can't get 240V between both of the poles.
The voltage of each POLE of the Electric Panel is 120V but the voltage between both poles is NOT 240V. I have also attached a video to this email.
I get Fault...