For HV protocols , i upload new DIYB4I v1 with more easy debug function . For testing the protocol just use fake battery data.
Also all ports can be tested for trafic / also the can msg comms
Most of Easun inverter not support can bms, just rs485 comm.
For 8 and 11 kw version exist an firmware update that support CAN will work with pylon protocol , i dont tested but u can try.
For u i simple just install Jk Bms Can Lv fremwere . conect one jk on rs485 one on serial the data will be combined . Select Pylon or Seplos. protocol. whatup on pm. The protocol is allready tested on solis lv.
best regards
Because of lot of project i support in same time i need to make some management of projects, is hard to me to re take all conversation from forum for each of u, and some contact me in viber or whatup or telegram and in this moment is a big mess with lot of info.
Sorry for that i try to give my...
CVL DVL CCL DCL and SOC are the data send to invertor by bms to work
CVL - Charge voltage level
DVL - discgarge voltage level
CCL - charge curent level
DCL - discharge curent level
u can send only from on jk bms to invertor but will not have the real amp readings , also change the charge...
i am not Shure what u mean!
If u have more battery packs in parallel all packs will have same voltage on enads so in theory is same SOC, but if u have a cell on 3.5 and rest are on 4 V the pack is not 90 % because the cell from 3.5V will discharge to protection faster!
so in the end when use...