Raul a/3's latest activity

The one I installed in March it’s been good so far, UK supplied 200A V3 with active balancer, yes the balancer gets triggered by the...

Do I remember correctly that OP has minimal to none insulation the van?

Since warm air rises, the furnace vents in my RV were placed near the floor. No additional fans or ducting needed ... simple and...

GWL in Czech Republic sell winston cells identical to those Calbs.

Swap your inverters on the outside ends of the bus bar, and the batteries in the middle, also make sure lugs touch the bus bar all the...

built the battery today. I had to use the EVA foam and epoxy sheets to get the batteries nice and snug (EVE280V3). There were a few bits...

Sounds like you want parallel 120vac operation but since you are talking about L1 and L2, you are feeding two parallel connected...

Yes, that’s correct, AC out 1 and 2 so the back feed is guaranteed 0w. Loads on AC IN side, parallel with the grid, will risk back feed.

This would only work on ac out though, correct? So any loads not on ac out will be unsupported

Best way is to find the D+ life signal, then connect that to H terminal. On smart alternators you have a simulated D+, but on older...

The generator startup will work, I adopted a different technique, ignore AC, then a flag assistant to call the grid on certain...

Negative. This is all experimental. I'll be moving to Adam De Lay's generator startup technique when I disable the ESS (eventually). No...

Clarifications on the charts above: Water Heater is on input of inverters (L1 and L2), in parallel to the grid. Kitchen range is on...

If you connect via bms studio, you have a option on the top right to update the bms firmware.

Just an anecdote - I have 3 x battery banks with Seplos V3 BMS and I have tested those individually at 180+ A continuous charge/...

Ah, sorry... posted my results in my signature thread, but to summarize: It was extremely easy to do. Connection via the...

RESULT, I bought an Ohme Pro Charger 'pre loved' last year and tried to set it up to charge the outlander, but because its a tethered...

Hi Alan, Thanks for posting here, it's encouraging to see some correspondence from Seplos. To be clear, all I want is to make sure...

The password is seplos111

Has anyone come across this previously? I’ve downloaded the battery monitor software, uploaded the right profile and logged in using the...