New to this so any chance you could draw this out as a diagram - I am looking to do this to make up for some supply change issues-
Background that you can ignore :p) I had planned a Electrodacus SBMS0 but they are out of stock so in a bit of rush ordered a JBD but only 100 amp version - and...
This is my first crack at electrical layout, I have a general power schematic and prettier Electrodacus/sense wire layout (discovered straight lines..) Building out an electrical supply system for my Sprinter Van I am DIY converting - pretty new to electrical systems so feel free to butcher...
Ok thanks I am comfortable I have the aux 1 and 2 set up correctly and once I get access to Victron configure I can set up the assistance correctly for Multiplus
What I wanted to explicitly know is I just leave the jumpers as received and I assume that is a yes
Pins 1-2 shorted...
did this sell
dumb question can you use the SBMS40 in the same way as SMBMS -i.e using it to trigger loads/charge sources that might be above the assigned 40 amp input 'special input?
I am about ready to buy solar panels - two small (100w) panels which I will parrallel to the DSSR 20 and then two larger 180W panels behind fan - I was going to buy a small MPPT but just saw Dacian has launched the new DSSR50 which I think is a nice cost effective solution -
Will the DSSR50...
Thanks I will look at that - ITs been a while so have updated a few things and now have a bit more time to spend on electrical system having completed some other van projects. I have major components purchased but now need to order cables and fuses so if anyone has comments on that
I have also...
Any feedback on suitability of the Alrksa panels in charging a 12V system via DSSR20/50
Purchased the 180W version on a special deal
Specs seemed to have been revised
180W
Imp 8.61A
Vmp 20.9
Voc 24.7
So the KISAE switch is in Off position and then is powered on by relay at the command of BMS.
With the switch in ON position it bypasses the relay and BMS control. I assume you considered the relay in series but then if that failed you could not defeat it using switch
Old thread hopefully someone sees this - do you remove the jumper (item H) on the multiplus if you are using the two signal bms function for eletrodacus?
Dssr for one set of panels 100w x2 and I will also have 150-200w x2 - can’t mix panels and additional dssr are not on sale / backordered
Assume you are using midea in a home vs a van (if the later would be interested to hear your feedback)
Background: Selected a Daly BMS 150 amp for 24V 280aH System for use in Sprinter RV
Battery: Buying/Building a 24v Battery Bank -8 EVE 280AH LiFePO4 (LFP) 3.2V Cells Battery LF280K buying through Amy @ AliB, As these are long lead items I am buying these first before I have everything else...