My EG4 is producing power!
I'm running in an off-grid mode with four 345 watt panels.
What I experienced:
- no battery rack
Still waiting. Signature Solar quoted 6 weeks delay.
The cables from the inverter are too large to attach directly to the batteries.
You'll need to wait for the rack or...
Just finished my Della install.
Took way longer than I thought it would.
I had to manufacture two connectors for the 240 volt lines. The connector on the unit is tiny. The wire I had on hand was 10 guage.
I had to manufacture a stand out of pressure treated lumber to sit in the grass.
Getting...
Just finished adding a second 30 kWH RUiXU cabinet to my Sol-ark 15k.
The process I followed to introduce a new cabinet to an existing one:
Fully charge RUiXU1
Solark config: disable battery
Solark: disable DC breaker
RUiXU1 power off every box
RUiXU1 change master dip 6 to off
Connect RUiXU2...
My home build LTO battery had a fire last night.
We heard a large pop and came out to find a small arc fire in one of the cells. One of the cells had popped completly apart. The wiring was arcing and causing a small flame.
We were running five 10 amp active balancers on five 22S banks...
I finally got the EG4 18kpv charging 6 lifepower4 batteries to 59% charged.
How do I get AC line voltage?
I'm running in off-grid mode.
I have 150volts of PV but zero volts on Line1 and Line2.
I am unable to update the firmware on my new EG4 18kpv.
I switch my phones wifi to the EG4 dongle and press
CONNECT DEVICE AND UPDATE
I select TCP Connection
I see error
connect dongle of device failed
I have tried
- 4 different Samsung Galaxy Note phones.
- restarting app
- restarting...
Shenzhen Toomen claims they are coming out with new Carbon Capacitor cells in 3Q-2020 that have:
20.0Ah 25000F 4.0VDC 120mm x 200mm form factor. Full spec attached.
I emailed Shenzhen Toomen to obtain 20 of their new cells for a 6 month evaluation.
The goal is to create a drop in...
I dont understand the RUiXU dip switches.
I have a rack of 6 batteries but the switches have no place to set the Can id.
How do you specify the master battery?
How do you specify each Can bus ID?
I need protocol ID 2, which is dip switch 6.
Do I set switch 6 on every battery?