Recent content by thedodgersonline

Hi I did read the thread after posting here. Rookie mistake - should have read the threads first I guess. I think you were talking to the JK shop on AliExpress. I was talking to the JKBMS factory. They have confirmed that - with the addition of this parallel module - you can wire them in...

Hi This is the wiring of the parallel module - when mine arrives I will open it up and have a look. Regards

Hi Just confirmed with the JKBMS factory that the latest version can be connected in parallel - but you need the parallel module? See Pic below

Hi Been dealing directly with the JKBMS Factory and it has taken all day but I finally got hold of some one who has some technical ability. So the latest model B2A8S30P (4S 300 amp ) can be connected in parallel but you need a parallel module. Trying to find out more about it and where to wire...

Hi Just reading this mega thread about this exact subject. Highly recommended as ther is a lot of input from JK (Nami) https://diysolarforum.com/threads/jk-4s-200a-bms.38623/page-1

Hi In the technical specs I will post a screen shot below No idea what the 'kit' is. According to the vendors it is an 'option'?? At this stage she stopped talking to me Will see what else I can dig out. According to the manual Parallel connections are allowed?? Confusion reigns REgards

Hi I have just discovered from LLT ( the manufacturers) that their BMS cannot be wired in parallel. I cannot get any sort of technical reason - just NO - sorry - not allowed etc. THis might be your problem. Just had a look at the technical spec sheet and parallel function is not allowed...

Hi Up until recently I have been happily building batteries (sporadically) and had standardised on the JBD BMS. When I went to order some more gear to build 2 new 12V batteries I noticed - in the spec sheet - these these were no longer allowed to be paralleled. This amazes me because I cannot...

Hi I had looked at that option but would need a lot of power ( crypto mining rigs) and with the cost of energy nowadays I want to run them off solar and battery. I already have the panels and battery just need an upgraded inverter system. Thanks and Regards

Hi Thanks for the response and throwing some clarity on the issue. Yes, I was asking about the transfer time - tossing up between the MPPSolar ( which boasts zero transfer time) and the Growatt. This will be replacing an older MPPSolar. Thanks and Regards.

Hi I am looking at installing a Growatt as a backup system for my computer systems. The area of concern for me is the change over time from solar to battery ( when solar is insufficient to power the loads) and from battery to line ( when battery gets low) Can anyone provide these details...

Hi Horsefly You are correct, apologies. When I first set up a battery (some years ago) I noticed the name was not written to the BMS. Regards Richard

Hi EcoRV I suggest that you join the app developer on GitHub and raise the issue. He is very responsive (as you will see by the resolved requests) and very open to improvements / suggestions. GitHub group here https://github.com/smagicld/xiaoxiangBMS/issues The issue of the pin is addressed...

Hi This is where you add / enable the PIN security. Also the naming of the BMS

Hi Rather than answer multiple threads Inthought I would summarise. 1. Yes you can name the individual BMS to differentiate however the name lives on the reading device not the BMS. 2. You can secure the BMS by adding a pin to each BMS. You can go as far as a double pin if you wish. 3. The app...