upnorthandpersonal Thanks for the quick response, those chips you marked are labeled (BCE1H). I would have been looking for what burned out for a long time, thanks for the prompt. We have where to buy them, yes, I have a lot of experience in soldering, thanks again, I’ll buy it and try to...
I replaced 2 of them from one side - 1 and the other side - 1
S47Bcj4 - the new
=====================
1 year I use - enjpower-bms-3.7.4.88
but now I install - 极空BMS_4-9-2.apk , the last app what support android 6
I soldered the diode instead of the LDO, now the A13 is powered by 2.9 Volts. But nothing has changed. I'll put this idea aside for now when I gain more strength =)
ordered these DC-DC after tomorrow should come. I measured the voltages incoming and outgoing from these DC-DCs, one comes out 3.3V from the other 4.5V. Something I haven’t met who needs 4.5V
I think know the problem.
smd component marked as r3dlb. do not know what is it, can't find datasheet. But IN +3.3 , out 2.0V
but A13 Amplifier (lm321) need supply from 2.7
I replaced the one that gave out 4.5V, nothing has changed. Then I calculated the volts, it turns out that all volts are correctly issued.
Vout=0.6*(1+R1/R2)
R1=104(100kOm)
R2=153(15kOm)
Vout=0.6*(1+R1/R2)= 4,6V
===================================
R1=683(68kOm)
R2=153(15kOm)...
I understood what happened, hk32f030mf4p6 was short of 3 volts, R3D is all working. I desoldered (hk32f030mf4p6) and 3 Volts was restored, signals from the T1 T2 go to hk32f030mf4p6. I don’t know if I can read (hk32f030mf4p6) and flash new one.
Hello? I have JK-BD6A17S8P and the same problem (Protection (CPU AUX Anomaly)). I use it in battary for scooter. External Temp sensors have 9.4kOm, voltage to sensors 2V. I do not think it's sensors problem.
==============================================
help me find the cause, where to look? I...