Most reacted threads

I recently replaced the two Daly BMS on my 48v lifepo4 battery banks with units from JK. They've been running fine for the last few days but this morning I noticed that only one of the two is showing up under the device list in the JK app. The led on the BMS is on and it seems to be working...

Setup: 2x MPII in split phase configuration running to Autotransformer 100A for load balancing, feeding a main breaker panel in a shed. Neutral and Ground are bonded inside the main panel. The Autotransformer instructions say that the ground relay in the AT only should be used and the ground...

Currently I am running 2 Multiplus II 48/3000/35s in split phase configuration. My problem is that despite my efforts to balance the loads in the breaker box, at times enough power is drawn on one leg to put the respective multiplus into overload while the other multi is just sitting there. In...

Currently my camper is plugged into an outlet powered by my 16kw 48v solar system, thus everything 12v in the camper is being powered by the on board converter. My thoughts are that rather than the power coming from the DC bus, inverting to 120v, then being converted back to DC, I could...

Currently I am using the charging settings recommended by Victron for my 48v Lifepo4 battery bank (3 sets of 16s 280ah cells): Absorption: 56.4v Float: 54.4v I have read and heard a number of times that for maximum battery life (number of charge cycles), the batteries should be charged no more...

From time to time I'll look at my CCGX in the evening after the sun has gone down and notice that the home screen reports negative wattage, usually -11 to -16w, in the PV box. When I look at the data from the two SCCs either through the CCGX or using VictronConnect, they both show 0W. Any thoughts?