silverstone
Solar Enthusiast
- Joined
- May 3, 2022
- Messages
- 1,041
I *think* the issue is that from Inverter/BMS point of view it already absorbed, thus is goes back to float.So i changed the AH value and it reset the inverter to align with the BMS/ESP values
but another issue is - now i have solar it won't charge beyond the 80% unless i change the float from 54.4 to 57.1 - is it safe to do this?
Same problem for me in Deye Voltage Control Mode at least.
"Safe" depends ... I'd tune the float back after a few hours *if* I were to adjust it that high. And check that 57.1V is NOT too much for your chemistry !