Search results

300W or 500W (Small) 24V Pure Sine Inverter - Any Suggestions/Recommendations? Thanks

Fair enough, but my assumption was that since less current will be required for the inversion, therefore less heat = more efficiency... No need for Big Transformers, Or Fans, etc... I am not savvy on this, I am just not sure why something like this is a common stream.. What I found is that...

I am assuming the efficiency of 120VDC to 120VAC will be much better...

5 MPPTs and 5 24V Batteries connected in serial to produce 120VDC native... And then much more efficiently transform it to AC? I was wondering if anybody tried this kind of setup? What am I missing?

I am thinking the auto-transfer will not work on, since as soon it kicks in and switches to leg2, then the standby mode will be trigger again... What about a simple bridge btw both legs? --> that actually will send 220V to the appliances.. VERY BAD IDEA!!!

Hi guys, I have a "naive" question. If I understood correctly the inverter will be in standby mode until the leg1 requires more than 25W, so microwaves clocks, standby TVs, etc will not be able to trigger the inverter... to resolve this, I was wondering: is it possible (again excuse my...

Ohh, I didn't know... THANK YOU FOR THE TIP!!

I was able to install the pole for the wind turbine in the fall. I will be installing the solar panels on the roof and bringing all the cables to the inside hopefully in the spring. So far this is what I was able to set up under one of the seats/storages in the dining area. I still need...

Thank you All!

Ohh, that's one of the things that I was concerned about, I am going to use a 2 AWG wire so I am not worried about power loss, in this case, would you still recommend 3S2P over 2S3P? Or Would you recommend 3S2P and inter place them [1A,1B,2A,2B,3A,3B] etc? [I am trying to maximize the...

Thank you all for your help!! I am taking from this I should forget about the 2S3P, GO WITH 3S2P AND if by any chance I cannot feet the 6 panels in the roof of my RV, perhaps go with 5S and have an extra panel around... I'll make sure to upload pictures once the spring comes and I am able to set...

In a 24V system, with a Victro MPPT 150V-60A, and 6 195W panels (see specs below), would you recommend having 3 panels in series and 2 parallel OR 2 in series and 3 parallel OR something else? I read in other posts that I should make sure to multiple the VOC*1.25 (I live in Canada) and make...