Search results

I discovered that applying a AC load wakes it up and the light goes solid. Thanks

Thanks

I have 2 inverters..a master and a slave. Only the master was blinking green I dont know what a Hub controller is. I have a two FLEXmax 80 charge controllers. Thanks

I have a Out Back FX series inverter / charger with two Flex max charge controller. The inverter has a master and a slave and each has a seperate charge controller. All of a sudden the master has a green light blinking. There is no sun today so the lights are yellow and blinking green when they...

Thanks again

Thanks for the advice. I made the mistake of buying an Anker 767. It is supposed to charge at a rate of 1,400 watts. I have a Yamaha 2000 watt inverter generator that cannot handle charging this thing. It goes from 220 watts to 1000 watts then back down to zero..then stars all over again. A lot...

Any recommendations for a 2000 + Wh solar generator? I am off grid and need it for the winter. I charge it with a 2000 watt gas generator. Thanks

Hello..I have a Bluetti AC200 that all of a sudden with not charge with the AC charger. I tried with the 12volt charging port and it also does not charge. Its out of warranty. Do you think the charge controller is bad? Can I replace it if it is? Thanks

Thanks everyone for the advice. I think I will replace with new L 16s.. I only use them to run lights, computer and tv. I shut everything down at night. I have a separate system for a 12v refrigerator that works fine. I can get new L16s for $320. Thanks again

what is DoD? The temperature is moderate. Concrete basement never below 40 or above 60. I do not know the charge rate. I have a outback system, with a slave unit.

I currently have eight L16 6 volt ...24 volt system. These batteries have lasted me eight years and need to be replaced. I do not use a whole lot of power. Should I replace them with lithium batteries or just more L 16s ? Thanks

Thank you

I think I'm confusing you guys. The L16 batteries I have been using for 6 years. I don't need the charging specs on them. They are FLA batteries. I am trying to find out how to charge the 2 separate 8S 24V lifepo4 batteries that I want to switch to.

US battery.

The batteries I am using now are L16 385AH (not 280) They are flooded batteries. The label on the battery just says L-16. The lifepo4 battery I want to use are 280 AH. This is off grid.

I currently have 8 L-16 flooded batteries, 6 volt, 280 ah in a 24 volt system. I want to switch to 2 separate 8S 24V lifepo4 batteries in parallel still 24 volts.

No..I am currently using 8 -L16 6 volt batteries. 4 in series for 24 volts. I have a Outback flex 80 setup.

If I have two 2 - 24 volt batteries (8 cells per battery) in parallel could you tell me what the charge settings would be on the charge controller?

Thank you for your advice. Could you explain "2 separate 8S 24V batteries" ? I like the idea of using whole batteries rather then the cells. Thanks again

I have 8 L-16 batteries 6 volt 385 amp hrs in a 24 volt system. I would like to replace them with lifepo4 batteries.. What would you recommend replacing them with?

The AH rate is 385 . I am not sure how to find what the peak draw is. I am off grid and I only use electric to run a television, computer, lights and a vacuum on occasion.

I currently have a 24 volt system. I have 8 L16 6 volt batteries..4 in series then the 2 banks in parallel. I have 12 - 250 watt solar panels charging the system. I have a Outback charger and inverter. I would like to switch to lithium batteries. How many lithium batteries do I need to...