frankz66
New Member
Hello everyone, I would like to make a 16s lifepo4 bench to be developed in a vertical position. does anyone have any reference to such a project? To be clear, a wall build-up.
Creation of vertical development lifepo4 bench
- Thread starter frankz66
- Start date
FilterGuy
Solar Engineering Consultant - EG4 and Consumers
I don't have a reference, but have thought about it some. The idea of a very flat profile pack is intriguing to me.
If you decide you need cell compression, these layouts could be challenging.
If you decide you need cell compression, these layouts could be challenging.
frankz66
New Member
Thank you . Yes, of course the cells must be absolutely compressed, due to their dilation. Of course in an upright position it becomes more complex . I should have, but I do not have, an explosion of a wall accumulation to here as they are made. moreover, the connection of the busbars should be of the same length so as not to incur voltage drops, even if minimal and corrected by the active balancer. Anyway, thank you for the time you have dedicated to me.
