Schneider XW Pro 6848 Fault Code F01

[cwinward]

I have 3 Schneider XW Pro 6848 inverters that I have configured for 3-phase power operation. Currently When powering the system one of the inverters throws a fault code F01 indicating "Low AC output voltage" and then all three inverters stop inverting. Any help in resolving this issue would be greatly appreciated.

 

[400bird]

Did you misplace your other thread?
If so, I found it for you:

Schneider XW Pro 6848 Fault code F01

I have 3 Schneider XW Pro 6848 inverters that I have configured for 3-phase power operation. Currently When powering the system one of the inverters throws a fault code F01 indicating "Low AC output voltage" and then all three inverters stop inverting. Any help in resolving this issue would be...

diysolarforum.com

 

[Tomthumb62]

Welcome to the forum. It’s considered poor manners to cross post here. It’s a small enough community that if you just post once, usually you’ll get someone to reply.

 

[cwinward]

Welcome to the forum. It’s considered poor manners to cross post here. It’s a small enough community that if you just post once, usually you’ll get someone to reply.

Thanks, was not sure I posted in the correct section.