a619's latest activity

Any of you able to migrate from PV pro to mysolark? Last time I tried, I couldn’t get it to register my WiFi module.

Shutdown = stop drawing from battery Low battery = usually just some low battery warning status Restart = if you hit shutdown voltage/...

1. Battery settings ONE Capacity= 304ah x 16 =4864ah (First image is wrong) --> This should be 304Ah, as the commenter above stated...

I have 3 Seplos mason kits running V3, 200A bms WITHOUT an active balancer. I have around 60 cycles on my batteries and all of them have...

I use double 1/0 cables with my Sol-Ark15k and at 250A+ continuous for an hour or so they only get mildly warm. I was using a single 1/0...

Class M should be higher rated. Somewhere around 250 if I recall.

Just an anecdote - I have 3 x battery banks with Seplos V3 BMS and I have tested those individually at 180+ A continuous charge/...

Yes, just use a switch instead of the dry contact interface on BMS.

No, that’s just a trigger to enable active balancing. That port is unused for assemblies without active balancer, which is what you want...

Sold.

Bump

I don't understand this at all. We emit the most co2 per capita....of the whole entire planet. You are arguing that the #1 per...

I reached out to them and the quote I got was slightly different.

I got hart@seplos.com , safe or not?

Reduced price

Can you clarify this comment? Does it mean the BMS will only train again if you charge/ discharge at > 0.3C or > 0.7C, where C being...

I asked because the picture of screen you shared suggest that it had issued at least 1 warning. Weird if you don’t see that on BMS...

I'm no expert, so take this with a grain of salt. Below is my understanding: 1. No. Factory defaults should be sufficient. 2. What's...

maybe that changed in newer firmwares. It used to be other way around, on by default.

I like the 15K and the 200 amp pass through is nice. It seems less complicated just to drop a 15K in.