Recent content by CHTS73

Just received 3 more 100AH 48V batteries to bring bank up to 700AH. Hopefully keep the back up generator from running as sun is usually always a day away. Please keep up the info on Update progress.

Add a 120V to 240V transformer or auto-transformer and you should be good to go.

So it would be suggested to do the "Standard Update" based on current and available firmware ? Thanks!

Do I have to be in front of the unit to do these updates? At this time, I have no critical loads on the inverter so a restart is not an issue.

On PV Grounding, only tie the panel metal frame or bonded mounting frame (IronRidge) to ground. Bring the PV- and PV+ only to the respective PV Inputs on the 6000XL. Do not share the PV- with other arrays. I found this out when I installed a 300V combiner breaker panel but had to...

I am still unclear about updates on my 6000XP. Here is what I see: FW Code ccaa-140A0A Suggestion Standard update 0A -> 0C: ccaa-xx0Cxx_2_comm_240204.hex 0A -> 0D: CCAA-xxxx0D_dsp_240204.hex 14 -> 18: CBAA-18xxxx_mppt_231224.hex Not sure if I should click on "Standard Update" or not...

When the inverter only runs, the top two fans are active and the lowest fan appears to want to run, and if you flick blades with a small object, you might see it slowly turn. Unable to throttle the amount of PV to make level of power determinations. Maybe Will would check that out? When...

A week ago, I connected my 6x385W series wired array to PV2. Thinking of future, I also included separae PV1+ but PV1- was derived from the common PV(-) from a new 300V PV disconnect panel. Turning on the PV2, the 6000XP went into fault/alarm with various codes. After a call to SS, it...

Also found out that the inverter 6kW PV inputs, (-) side can not be ground referenced as is the case with MidNite Classic 200. A mixed bag of fun on converting to new inverter/charger. Thanks for letting me know on the 2 fan for inverter and one for PV. When I called CC, they said they have...

On Saturday, I connected my first string of PV panels (6x385W ME)to PV2 input. My other string (12x200W Sharp) is still charging EG4LL batteries through a MidNite Classic 200. Apparently, the EG4 6k Inverter does not like common return on the PV inputs via a new 300V PV Disconnect...

Update: Today I connected 6 each 385W ME panels in series to PV2 port. PV voc was around 275V as expected. Aftrer that, I expected the 6000 to charge the EG4 battery bank but the 6000 produced an assortment of faults and alarms See attached picture. Anyone have any clues what is...

I notice that only two of the 3 cabinet fans run when I have a load. Does anyone have info on the 3 wires used on these fans? The new fans ordered from Digi-Key have 4 wires. Most likely PWM and TACH leads but unknown what the OEM White lead function performs.

Hi, When you say starts up at 60 watts, do you have a PV voltage level reference to go with that?

My 48V Off-Grid system has 12x200W panels on DA Tracker wired 4 in-series to a MidNite 200 Classic. I just installed a 6000XP inverter & 4 each EG4-LL and also curious how it will react to 100-130VDC as PV Input. I have a 2nd fixed array 6x385W wired 3 in-series and plan to rewire it for 6...

So how do I enable the items to appear below signature line?