Recent content by Jumpy07

Did you get sorted ? Just a thought if you havent.. have seen some threads of people have comms issues with BMS due to RF noise.. which were solved by wrapping the CanBus / RS485 cable and battery cables around a ferrite ring... might be worth a try

What version of battery do you have A, B, C8 or C16 ? Also what is your current version ? Console cable is same as Cisco.. cheap as chips on Fleabay... I doubt its the firmware thats causing the issue.. once you get a console cable sorted you will be able to see error codes and if the BMS is...

Yeah latest version of Solis Cloud they have removed the option to configure the battery.. only option is to configure on Inverter.. I have to use user defined battery

What firmware version are you currrently on ?

Looks like in latest Solis update they have removed the ability to change the battery type through the control option on Solis Cloud.. bummer

Lol... no Tandy TRS80

This is the Solis Cloud Log.. appears to have accepted Pytes as the battery type..

Just noticed that when you have control enabled in the Solis Cloud app you get a much longer list of supported batteries than you get on the Inverter menu... and Pytes in listed.. when I choose this, the battery type on the inverter shows blank... but appears to work

Its Its a temperature issue, I had the same problem, your batts are too cold... latest firmware kinda helps though as its not as restrictive..

Ok thanks for the guys on here for helping me out.. but WARNING DO NOT ENTER BOATLOADER UNLESS YOU ARE UPLOADING NEW FIRMWARE AS THERE IS NO WAY TO EXIT THE BOATLOADER UNLESS YOU DO. There are also three versions of the battery, A, B, and C at the current time and firmware is unqiue to the...

Yeah that would be great if you can post it

Did you get it out of bootloader. ?.. if so how.. I stupidly was messing around and put it into boatloader mode.. havent uploaded new firmware.. so kinda hopeing it times out.. have tried everything to reset it

How did you get one with these ?... just ordered a 20w pad, my batt is wall mounted so easy affix to outside and then insulate.. just going to use the temp controller that comes with it..

This is my battery firmware version etc for reference.. (bought last week) @ Command completed successfully $$ PYTES_config>info @ Device address : 1 Manufacturer : PYTES Device name : E-BOX-48100R Board version : SQBMSV15 Main Soft version : SPBMS16SRP2203V1.5.4.C8...