Recent content by Meeko

That was my bad key board auto corrected to the 30 amp TR

The new xs is 50amp

Indeed, utilizing a higher amperage rating is preferable in this scenario. Considering the 50 amp DC to DC conversion and the 25 feet run, I opted for 4 AWG cables. The price difference between 4 AWG and 6 AWG was negligible.

Hello everyone. I was in the process of connecting our new DC-to-DC charger, the Orion xs Smart 12/12-50A. One of the advertised features was its compatibility with 4 AWG (25 mm²) cables. However, I encountered a challenge when attempting to insert all the copper strands into the designated hole...

Thanks for the input

Ty

I just switch over my system to victron solar controller and lynk distributor and a new battery. I was doing some work this morning, so shut off my bluesea 6006, I always check for power and yes volts coming through, is this because the solar controller is feeding the battery? So I should turn...

Anyone seen these? Only available in the UK, been watching a gentleman on YouTube with a van using them near the arctic. https://roamer.com/

Will do, just waiting for connectors for my solar.

Have not tested, negative ground from van battery to common neg busbar.

We thank you all for the input and added info from you guys.

I know, just didn't want tighten everything then have to take it apart again. ? Good eye. Much appreciated.

I know all lines are loose, and yes to pre charge. Ty

I routed it under the table top to avoid the wires from crossing. It goes to the solar controller negative. That's 2/0 on the battery, from main battery fuse to positive fuse block is 2/0, and also 2/0 to the inverter negative is 2/0 to the shunt to the bus bar and 2/0 to the inverter...