diy solar

diy solar

Most reacted threads

  • SRNE SCC charges with too high voltages

    In a friends cabin, we replaced a 20 A (Epever) charge controller with a 40 A SRNE SCC (SR-ML2440), and doubling the installed PV to 520 Wp. The batteries are (old) 6 V, 235 Ah FLA in 2S3P configuration. The new SCC is configured for FLA, but the voltages frequently reach and even go beyond 15...
  • Heated SOK batteries in series

    I am putting together a kit for a really cold climate (northern Quebec, down to -40 C and below). I am planning to build a box of 4 inches of foam board, and use heated SOK 100 Ah batteries, 2 in series for 24V. The manual of these batteries states that they can only be put in parallel, which...
  • Self-heating battery: Problematic behaviour?

    I am running test with a self-heating battery, and I noticed a certain behaviour when charging at low temperatures, and I am wondering if that could cause a problem down the road. The battery is at -11°C (below freezing), and when I apply a 1 A charge current, the following happens in the...
  • Batteries arrived with low state of charge

    I ordered 2 SOK 12 V 100 Ah heated from SOKs Canadian site. I noticed that neither one of the two BMSes showed up in their app, although they are supposed to have Bluetooth. I then measured the voltage, and in both cases it is at 10.9ish volts. This means that the battery is below 10 % SOC, and...
  • High cost vs low cost fuses

    Does anyone know what the differences are between high quality fuses (like ANL or MEGA fuses from Blue Sea Systems) that sell for over 40 CA$ a pop, and low cost ANL fuses (from Amazon, 17 CA$ for 6)? I tend not to save money on this end, and I totally get why cheap circuit breakers are a no-go...
Back
Top