diy solar

diy solar

Most reacted threads

  • How many solar panels can I fit on my rooftop?

    Hi all, I have a flat rooftop with the following size and orientation: I am planning to use JA solar 545W (2279 x 1134 x 35 mm) solar panel with 30 degrees inclination. Also I am planning to use this type of structures with ballasts. Any guess on max solar panels? Thanks
  • Received this item with my Inverter. What is it for?

    Hi, I have received this item with my DEYE sun-8k-sg01lp1-eu inverter gear. I am not sure what it is for. Could anyone help? Thanks
  • Battery configuration for a 16 bank EVE 304

    Hi there, Trying to figure out the best battery setting on an inverter deye sun-8k-sg01lp1-eu for a 16 x EVE 304 bank. Battery specs: Here my calculations and my config settings at the moment: 1. Battery settings ONE Capacity= 304ah x 16 =4864ah (First image is wrong) Batt Mode = Use Batt %...
  • Newbie Help: Axpert (Voltronic) MAX 8000 PV electrical design

    Hello everyone! I have been reading this forum, and it has been a great source of knowledge. Thank you all for sharing. I have been designing a PV (Photovoltaic) system for my country house. I have extensive knowledge of electronics, but some power aspects are challenging for me since I...
  • Deye sun-8k-sg01lp1-eu clips production at 20A in one of the MPPT

    Hi all I have a clipping issue on my installation. My installation consist of - Inverter: Deye sun-8k-sg01lp1-eu - Solar Panels: 18 JA Solar 550W. - Wiring: Two MPPT in use. First one with 8 panels in series. Second one with two string of 5 serial panels (5+5) I have a problem in the...
  • DEYE SUN-8K-SG01LP1-EU ground connection

    Hi there, I am wondering how the ground connection to a DEYE SUN-8K-SG01LP1-EU should be done. For context, this is EU-based instalation. This is the recommended wiring for single phase EU grid connection: That will not provide ground connection. However, on the point 3.7 it mentions the...
  • Sizing battery based on energy production & consumption

    Hi all, I am trying to size my battery based on my energy production & consumption: On the production site. My house roof is 10x6 m2. Long side 10m is 135 SE and short side is 225 SW. So I have calculated I might be able to fit 14 JA solar 545w panels. Based on my latitude and longitude (42º...
  • DEYE sun-8k-sg01lp1-eu configuration

    Checking the DEYE sun-8k-sg01lp1-eu manual I am unsure about how to configure the inverter to work on the following mode. - Primary power source: PV. It will be used to power the loads and charge the battery. Any excess production will be sold to the grid. - Secondary power source: Battery...
  • DEYE SUN-8K-SG01LP1-EU wiring to PV string

    Hi there, I have a couple of doubts regarding the wiring for the SUN-8K-SG01LP1-EU inverter. These are the specs for this inverter regarding PV string input I am intending to connect 18 panels. Since there are 3 panels affected by morning shadow and the other 3 affected by afternoon shadow...
  • DEYE provider (SUN-8K-SG01LP1-EU)

    Hi I am interested to purchase a deye hybrid inverter SUN-8K-SG01LP1-EU. I have contacted this seller on Alibaba https://www.alibaba.com/product-detail/DEYE-energy-storage-power-inverter-SUN_62009450583.html?spm=a2700.shop_plgr.41413.7.7d2d13ec6MmNj9 Has anyone experienced purchasing from...
Back
Top