Close, there is no dim for the 3/4” knockout fot thr communications but you can extract its dim from the 18k knockouts, and also the knockout for the PV seems to be a different size.
Is there a drawing anywhere giving the dimensions to the locations of these knock outs.
I’m replacing 4 6500ex inverters with 3 6000xp and need to locate them above my Wireway.
I’m building an off grid setup.
I have a generator that will fire up on a contact closure (2 wire start)
I have 12 Lifepower4 batteries in two banks 60Kwh of battery.
I have a Chargeverter that I’ll be hooking up.
Can I leave it connected to the battery bank permanently so on low SOC, I’ll...
I had similar issue with this cold snap. System shutdown low SOC. 8 of the 10 batteries came back and charged ok. 2 are basically dead. the come up flashing red with an alarm. I broke them out of the battery bank and put them on the 18A charger but they will not charge.
hopefully SS will get...
I’m just bringing online an off grid system. I have 2 inverters and 2 more to flash with the most current firmware.
The only flickering so far is when the contractor was running his airless paint spraying. This flickering can also be seen when on grid as the pump draws high current when pumping...
I bought 4 of these breakers but changed the way I was connecting my system. They have never been used.
Two are in original boxes two are open.
230.00 for all 4 shipping included to lower 48 states.
Link to breakers
I have 4 EG4 6500EX. Two inverters in parallel/ split phase. 13k each leg.
I have two programmed 2P1 and 2P2. They work fine giving me 120/240 @~50A.
How do I configure the other two to run in parallel? Wiring is no issue the diagrams are provided.
Thanks