Recent content by waterflea

Thanks wheisenburg for the feedback. This is a picture of the most current AC buss configuration which seems to be working without a hitch. I do have one question. Is it typical that the master always puts out more power than the slave and is this ok? For instance, not much draw right now but...

Both inverters are showing this message. Dashboard shows batteries at 56.1V.

After ten plus days with no sun to speak of, we are getting a week of it. Batteries are getting full already and I got the error message below. Any cause for alarm? What should I do about this?

So BentlyJ was kind of right....it didn't start out that way but as soon as I figured out that it wasn't a generator issue, this post started to duplicate an on going post I started about the commission of this system. If you're interested, the title of the other post is "Schneider XW Pro...

So the good news is the inverters are staying on. The Master shows 27.5 amps and the Slave shows 27.9 amps. InsightHome shows 3.3kw coming from the generator. Thoughts?

Good advice 400bird, High Battery cutout was 65, tried to get to 56.6, lowest it will go is 58. Bulk Termination Voltage is 54 and that is the highest it will go so 56.2 is not possible. I'm about to give the generator a try with these new tweaks.

I tried lowering the specs for Bulk Termination and High Battery Cutout and when I hit apply they usually turn green when accepted. They turned red.

I do have the Conext Battery Monitor system but the one they sent me would never connect with the InsightHome. They are sending me a new one. I think I posted these before but here are the Pytes battery specs that were sent to me.

Sorry, this one has all the settings open

learn something new everyday

What is the easiest way to post all the settings?

Sorry Bentley, Schneider TS led me to believe my problem was a generator issue not a commission issue, so I started this post asking for ways to regulate the voltage from the generator and it progressed from there. The other post is just a continuation of my commissioning trials and...

When working with Schneider TS, he had me put the slave inverter in standby and just try the master. Nothing really happened. The generator was running but the inverter wouldn't ramp up and cutout like before. It just wouldn't accept the incoming charge from the generator at all, where as...

When working with Schneider TS, he had me put the slave inverter in standby and just try the master. Nothing really happened. The generator was running but the inverter wouldn't ramp up and cutout like before. It just wouldn't accept the incoming charge from the generator at all, where as...

Maybe, but the generator never misses a beat. It's the inverters that stop the whole process from continuing. Like I said, this is a new commission and all new to me so any help would be appreciated. There is some talk on these threads about tweaking the inverter parameters to better qualify the...