Sportzfann
New Member
- Joined
- May 17, 2020
- Messages
- 93
I am looking for some steps to follow to install dual CC.
I installed 4x325w panels on my rv roof I have some shading on a couple panels I guess during the summer less shading?
I have 1 150/45 blue smart CC installed and it is maxed out on the amps, the panels are in a 2S2P configuration. (Seems to max out at @600w during full sun)
I figured I should be getting more from this array and spoke to others in this forum and thought I was limited by the controller, so the cheap route was to buy another 150/45 and separate the array to 2 pairs of panels 2 on each controller.
I wanted to ask about the settings so both controllers are at the same setting for bulk Volts and float Volts?
can I make the changes on my phone app so they are both the same settings ?
I don’t have the funds at this time to buy a Cerbo, so I just need to run these as stand alone for now.
Because of some shading is the best configuration to parallel 2 panels to each controller or series to each controller?
Should I have 1 shade panel with one full sun on each CC so they both have a little shade on each pair?
I attached the battery specs from Litime, and the panels I installed.
Thanks, Sportz
2x 200ah Litime batteries
4 jinko 325 panels.
I installed 4x325w panels on my rv roof I have some shading on a couple panels I guess during the summer less shading?
I have 1 150/45 blue smart CC installed and it is maxed out on the amps, the panels are in a 2S2P configuration. (Seems to max out at @600w during full sun)
I figured I should be getting more from this array and spoke to others in this forum and thought I was limited by the controller, so the cheap route was to buy another 150/45 and separate the array to 2 pairs of panels 2 on each controller.
I wanted to ask about the settings so both controllers are at the same setting for bulk Volts and float Volts?
can I make the changes on my phone app so they are both the same settings ?
I don’t have the funds at this time to buy a Cerbo, so I just need to run these as stand alone for now.
Because of some shading is the best configuration to parallel 2 panels to each controller or series to each controller?
Should I have 1 shade panel with one full sun on each CC so they both have a little shade on each pair?
I attached the battery specs from Litime, and the panels I installed.
Thanks, Sportz
2x 200ah Litime batteries
4 jinko 325 panels.