Search results

I just got my new EG4 indoor Powerpro battery in. It came with lengths of 2/0 battery cable with the special ends that the battery uses. However, I'm a foot or 2 short of length to hook them into my existing DC bus bars. What type of connector should I use to connect high-current fine-stranded...

I've had 4 EG4 3kw inverters and 6 EG4 lifepower batteries connected to Solar Assistant now for several months. SA's running on a Pi 3 It's been working great, except for the past 2-3 months. After being up for around a month, the web interface starts getting really laggy, then grafana graphs...

Ignoring the NEC rule regarding maximum number of current-carrying conductors in a conduit, how easily/possible will this cable pull be? I haven't buried any conduit yet, so plans can change, but I'm seeking to integrate into an existing 1" conduit where I'll be pulling the existing conductors...

I have 3 EG43000EHV-48 inverters in split-phase backed up by 6 EG4 LifePower4 batteries. All of the batteries were purchased within 6 months of each other and commissioned at the same time. When charging the batteries, 1 battery appears to hit 100% while the others are around 70% charged. The DC...

I'm 95% off-grid for my system in its current state. After a couple poor sun days, my batteries get lower than I can reasonably recharge with the panels I have, so I have the grid hooked up to recharge during those periods. I have 4 of the EG4 3kw inverters in split-phase mode hooked up to 30kwh...

With the recent video from Signature Solar regarding neutral/ground bonding recommendations and my permanent install of 4 3000EHV-48 inverters in process, I'm thinking about how my neutral/ground bond should be configured. It looks like SS's video is specifically in regards to their 6kw units...

When I built out my system, I included a Class-T fuse holder inline with the main cable coming off the battery rack bus bar. I'm using 4/0 105C-rated welding cable from the battery bank bus bars to the main distribution bus bars. The total run one-way from the distribution bars to the battery...

I have a pair of EG4-3000EHV inverters setup in split-phase and a bank of 6 EG4 Lifepower4 v1 (as far as I know; purchased in mid-2022) batteries. I have closed-loop (RS-485) communication running between the inverters and batteries. Solar Assistant is working great for the inverters, and...

I'm working on engineering my "ground" mount for a rack of Bluesun 460w bifacial panels. Due to the place I'm planning to put the array, at least some of it would need to overhang a different roof. I estimate I'd have at least 25% of the length of the panel unsupported. I don't think that will...

In a system of, say 4 EG4 3000EHV-48 inverters setup in split phase (2 per leg) is it possible to have a mixed configuration where 1 inverter on each leg is set in the on/active mode, while the other 2 set in eco mode? The goal would be to reduce the parasitic standby load of the additional...

I have a pair of EG4 3000EHV-48 inverters. However, with my available wall-space and the clearance specified in the manual for airflow/cooling, I'm having trouble cramming them on the wall, much less potentially adding 2 more to move more of my load to solar in the future. In the manual, I...

I feel like I made some generic beginners mistakes, and now I'm trying to figure out how to make the best of what I have. I'm seeking to build up an off-grid solar setup capable of powering a shed and an RV with 50-amp service. Now, from the get-go, I know that what I purchased isn't remotely...