Search results

I do have a seperat breaker for the Converter. Once I get the new cable and get it cut to length, I will do the steps, 1 to 8. I t will be a couple of days. I live in a very small town in Maine, so I have to order everything.

They told me on the phone, and when they said 2 they probably meant 2/0. I can change the wore and the breaker. I just do not really know how to replace the AC wiring. I have a Traill Manor trailer, and all the wiring is run between the floor and under the tub.. There is no way to access it...

2/0 wire could be challenge with the very short runs, but it is doable. Strange Renogy would recommend #2AWG. I have a 200a breaker now. I am not sure how to run new #6 wire from the converter to the battery compartment. The only way is probably to drill holes in the floor for both exit and...

It is #2 AWG and that is what Renogy recommended, had not changed the diagram. The distance to the power center is less than 3 feet. It is basically impossible to access the wiring because it goes under the tub and between the floor. It is a WFO power center with a 8955 55A converter. The...

It is just a 2000W pure Sine Wave Inverter. Renogy does not have a model #

Wireing Diagram. I used Adobe and cannot figure out how to attach a link

the fifth wire is the Converter. When the switch is off the monitor show Ahat 200, 13.6V, and watt usage of .24W. Not sure how this works with battery turned off

When the switch is off the Shunt is still monitoring the battery now. When it is Open/on is when I get the surge in Amps and watts used

The shunt is wired to the battery negative. You can see the black cable at the wall at the bottom. That comes from the battery ans connects to the shunt. The inverter negative is one long wire from the inverter to the last lug on the bus bar. Are we talking like a 10A fuse for the red wire...

When I have the shore power on and the battery shut off, the Monitor shows .24W being used. When I disconnect from Shore Power and turn the battery switch on the monitor shows3.2A being used and 40 watts. When I turn on the Inverter with the battery on the load goes up to 3.98A and 50W. There...

I want to get more general. It seems really good breakers like the BlueSea ones are just as good a fuses. Are there specific cases where breakers are just not usable or is it more history and personal preference. If you size the breaker correctly and it meets the specs for the use case why...

Refrig

yep on the AC side. The breaker controlss all the outlets and the power to the Alde monitor and Retrig fan

It is the GFI breaker on the trailer panel. As soon as I turn it on even with the inverter off the the load for watts and AMPs just jump up like crazy and the Renogy battery monitor, even though there is nothing on accept the fridge. It is a small frig in a T@B 320 CS-S teardrop. Within 10...

I have two 175 w Renogy panels, a Renogy charge controller, a 2000w Renogy invertor, 2 100amp AGM batteries and a Go Power TS30 transfer switch There are top issue. The first is that as soon as I turn in the GFI breaker the monitor shows the system using between 8 and 10 AMPS and 60 to 80...

I will second the comment on super hero. I have been sniggling with the same issue. I did not want to move forward with wiring until I knew the answer. Today I will complete the wiring. It would be nice if Renogy just included the great diagram Snoobler drew. Life would have been so mcu easier.