Hello..I have a Bluetti AC200 that all of a sudden with not charge with the AC charger. I tried with the 12volt charging port and it also does not charge. Its out of warranty. Do you think the charge controller is bad? Can I replace it if it is?
Thanks
Thanks everyone for the advice.
I think I will replace with new L 16s.. I only use them to run lights, computer and tv. I shut everything down at night. I have a separate system for a 12v refrigerator that works fine. I can get new L16s for $320.
Thanks again
I currently have eight L16 6 volt ...24 volt system. These batteries have lasted me eight years and need to be replaced. I do not use a whole lot of power. Should I replace them with lithium batteries or just more L 16s ?
Thanks
I currently have 8 L-16 flooded batteries, 6 volt, 280 ah in a 24 volt system.
I want to switch to 2 separate 8S 24V lifepo4 batteries in parallel still 24 volts.
The batteries I am using now are L16 385AH (not 280)
They are flooded batteries. The label on the battery just says L-16.
The lifepo4 battery I want to use are 280 AH.
This is off grid.
Thanks for the advice.
I made the mistake of buying an Anker 767. It is supposed to charge at a rate of 1,400 watts. I have a Yamaha 2000 watt inverter generator that cannot handle charging this thing. It goes from 220 watts to 1000 watts then back down to zero..then stars all over again. A lot...
I currently have a 24 volt system. I have 8 L16 6 volt batteries..4 in series then the 2 banks in parallel. I have 12 - 250 watt solar panels charging the system.
I have a Outback charger and inverter. I would like to switch to lithium batteries. How many lithium batteries do I need to...
I think I'm confusing you guys.
The L16 batteries I have been using for 6 years. I don't need the charging specs on them. They are FLA batteries.
I am trying to find out how to charge the 2 separate 8S 24V lifepo4 batteries that I want to switch to.
I have a Out Back FX series inverter / charger with two Flex max charge controller. The inverter has a master and a slave and each has a seperate charge controller. All of a sudden the master has a green light blinking. There is no sun today so the lights are yellow and blinking green when they...
The AH rate is 385 .
I am not sure how to find what the peak draw is.
I am off grid and I only use electric to run a television, computer, lights and a vacuum on occasion.
what is DoD?
The temperature is moderate. Concrete basement never below 40 or above 60.
I do not know the charge rate. I have a outback system, with a slave unit.
I have 2 inverters..a master and a slave.
Only the master was blinking green
I dont know what a Hub controller is. I have a two FLEXmax 80 charge controllers.
Thanks
Thank you for your advice. Could you explain "2 separate 8S 24V batteries" ? I like the idea of using whole batteries rather then the cells.
Thanks again
I have 8 L-16 batteries 6 volt 385 amp hrs in a 24 volt system. I would like to replace them with lifepo4 batteries.. What would you recommend replacing them with?