hogback's latest activity

I'm running 1.18 on insight facility with xwpros, and I can't remember what is on the gateway for the xw+, but it's at least four if not...

Yes you do it indirectly by using the battery/mppt V. I don't understand all the confusion. You dump load with a relay at float or a bit...

Gateway (basically insight facility) works fine with xw+.

I wouldn't. And the inverter jk does not work plug-and-play with Schneider. What features were you hoping to utilize?

Got a response from se that with firmware 2.4, the primary and secondary do indeed need to be "physically common" due to a new balancing...

I calibrated the voltages. They are each within 0.5V of 240, L1 to L2, and to each other. Still, to actually get V to show up on the...

Perhaps this thread should be in one of the inverter sections?

No change really.... I am noticing that the ACV of the inverter that is now working is about 121V L to N. On the other inverter, it...

So I did discover one interesting thing just now... So I restored factory defaults on both pros, reset grid codes, and filled in all...

Condensed questions: Should the N and G be shared between two 'independent' off grid systems? Do two xw pros need to have their load...

By floating, I mean they are connected by the same batteries, xanbus, and sync cable, but nothing else.

So, by pressing both power and equalize buttons, but only momentarily, will 'enable' invert. This only worked on one of them - the...

So, I had mentioned in another thread that I thought I might have fried one of my xw pros. All settings in insight home greyed out -...

The master will report the total capacity and adjust it if one pack goes down. And I suppose some sort of soc average. I couldn't get...

Ok, got batteries swapped, and all looks good.

Indeed. I have said incandescent ready to go. That being said, I never precharged when I flipped on the 4x simpliphis I installed four...

Oh, and I realize now that the 250A dc breaker off/on should also be steps right before/after battery swap.

Off grid and thinking of the proper way to swap out some new batteries. Can you remove batteries while the xw is in standby, or should...

In your situation it probably doesn't matter if AC Coupling is Enabled or Disabled but I would Disable if its not needed. Should not...

OK - I will check to see how it's set when I can drag my laptop out to the shed. Thanks,