Recent content by hogback

Should I paint it like Thomas the tank engine?

So I took everything apart to add a PT ply base with a layer of Grace shield and one layer of 2" polyiso. I also have some 1.5" neoprene for the sides, but haven't messed with that yet. Eventually would like to cover the outside with scraps from an old redwood water tank, for aesthetics and to...

Anyone using something like https://www.arcticheatpumps.com/pool-spa-heat-pumps.html for hot tubs/soaking tanks? Capacity-wise, don't seem to cost a LOT more than than the air to air minisplits, and have pumps (I think) built in. Seems plug and play.

Interested in the 60 150s if you want to split it up....

Indeed. Joking. But I wish there was that function.....

Certain fungus can work like ctl alt del for wetware

Yeah, like a little hole you push a pin in to set everything back to original firmware. Could have used that a couple months ago when everything was so bricked (in a pro) that all insight selections, including restore defaults, was greyed out. In the end I believe it was BECAUSE I was using an...

Do they mars ground their systems with marsing rods?

Wetware reflash.....

For off-grid, meant to say.

It's my understanding that xwpro will work fine with the most recent firmware updates, both for the inverter and insight. Xw+ is a different story.

Just set the xw and the mppt to the bulk/absorb/float that sok recommends. Xanbus terminated? How is the insight powered? Keep trying? I recall that last one worked for some people. After you upgrade both insight and xw firmware, you will want to restore defaults and reset the grid codes.

Charge controllers? Schneider? Generator?

May burning for me today. Probably could have made it fine with the Mitsubishi hp, but it rained an inch and the roof is a little leaky, so I wanted to dry it out a bit.

Isn't that all it's doing in terms of a pge interaction? I'm not familiar with the proposed equipment, I must admit.