For u i simple just install Jk Bms Can Lv fremwere . conect one jk on rs485 one on serial the data will be combined . Select Pylon or Seplos. protocol. whatup on pm. The protocol is allready tested on solis lv.
best regards
Om jk info page u have:
Inverter Disconected
Msg receive ID
Msg receive
Ur inverter is connected to can?
Normal the inverter send some Can MSG back evry 1s or more
That id and msg apeer there.
If no msg from inverter the inyerface will wait for it and from here can have lag.
If no msg...
From the invertor display if u can check if the data are same on chaege voltage and charge curentt limit.
Other people try with Pylontech tell me disconecting and have some diffrent parameters.
to cut the pack from the invertor u have external switch.
some invertor dont need to send amp readings from bms and u can use only jk balancers for ur pack, some need amp reading from bms and in this case u need a curent sensor. I use an JKbms only for the current sensor , but in the end i...
For HV protocols , i upload new DIYB4I v1 with more easy debug function . For testing the protocol just use fake battery data.
Also all ports can be tested for trafic / also the can msg comms
voltronic dont support can port, maybe they work on rs485 i dont know.
All invertors migrate to can bms support, on mpp solar / easun / other chinaese copy they start to have can support after last update
https://www.mppsolar.com/v3/pip-max/
i have rs485 from seplos and pylon protocol is...
Because of lot of project i support in same time i need to make some management of projects, is hard to me to re take all conversation from forum for each of u, and some contact me in viber or whatup or telegram and in this moment is a big mess with lot of info.
Sorry for that i try to give my...