Rocketman

That plan looks good - hopefully the Renogy inverter/charger works well for you… I don’t know anything about that AIO Inverter. From...

I have a 600w array on a Victron mppt 100/30, (clips above 440w), it does work in that range, but it also tends to cause some issues...

When I was considering starting my Onan Generator with my Victron CCGX, I discovered a module that I almost purchased (I later decided...

I would get a Victron mppt 250/60 (or 250/70), and wire one of the arrays to it to just charge the batteries. That way both arrays are...

Does your inverter have two separate mppt channels? Do you have a battery? - if so the easiest thing may be to put one array just...

You still can do a ground array - get 4 panels hook them up in series, then connect to your ground mount mppt. That’s if you decide you...

If you carefully select the ground mount panels so they work well with your roof mount array - yes you can. They will just be another...

I think everyone has the wrong idea about winter- if you are not getting enough sun in the winter to keep the battery full - go south -...

You are looking for differences - are they all around 3.000v or are the all but one at 3.125v and one is at 2.850v. Also on charging...

It has Dicor on it - I think this photo was taken towards the end of the project- before that step.

I have been helping my Brother-in-Law design his system. We went the same way using the PowerIn’s as the Main Bus Bar. Here is a...

I don’t worry about theft because if you steal my Starlink you can’t do anything with it - cannot be reused unless the owner transfers...

Some of the BMS built in counters are not known to be accurate. You may want to get a Victron Smartshunt (or Bmv712) to accurately...

Mine is the Gen2 so it points itself. I got a FlagPoleBuddy system and usually attach it to my ladder w/2 4’ poles (starts out at about...

With Starlink it varies- but it is all “fast enough”. I just tested as I was writing this In Arkansas (11pm) and it was the slowest I...

I think you can zoom on my dad’s brackets in the photo. He cut two 3” pieces. One he bolted onto the bottom of the solar panel frame...

As a full-time RVer - for us Starlink has been awesome! $150/mo (roam) and I can get signal as long as I don’t have too many trees above...

I used 2” “L” angle stock .125” (from On Line Metals). I made mine 6” long. I used eight prices per 200w panel - bolted four to the...

Thanks for the catch… typo between the brain and the finger…. I fixed the above statement to be correct. 😎

Ok back to interesting problems of mis-matched panels… One other idea. Add a mppt. Mppt#1 100/50: put the two100w panels in parallel-...