S Davis

About this point I found this and other sites about lithium batteries and decided to redo the system with a new lithium bank, I could...

Yes that picture is just dry fitting, if you look it is not connected in the breaker yet either. I’m doing 12 boxes so needed to do a...

Mine came with a small ground screw on the front panel, down low right side. If stacking I would use some type of rubber between four...

Order single terminals.

Yes exactly, if you look I was saying no I didn’t trust the breaker and yes to a class t on each pack. That is what I am doing, breaker...

Yep, for me that would be 800amps to pop the four 200amp class T fuses in each battery. It would not be pretty I am sure, I have seen...

The short answer for me is no and yes. As far as I am concerned a class T is required with the potential of these batteries, I am...

I talk to her on Alibaba chat. Occasionally there is a delay. Usually she's quick to reply.

I chatted with her last night, but it is a holiday today. I am negotiating a couple deals and all three went dark last night. I am...

1) It's a labour holiday over there May-01-05. 2) The time difference is a bugger too. 08:30 here = 20:30 there (I'm in EST) I found...

Do you have separators between the cells? I normally try not to press concern on others, but in light of build issues that have come up...

Especially after a recent thread I advocate a class T at every battery pack, as close to the pack as possible, and before the bus bar...

Broke down and bought a lift, last boiler change had the ceiling too low to use the block and tackle.

That’s why I decided against the inverter model, I order 22 for these projects. I got four spare.

He is ordering a new inner compression panel because it has custom mounting for the BMS he is changing to. If you ordered a box it is...

If you want to disassemble to change the fuse that works too.

Ok

Not where I am working with the breaker off, before the breaker on the cell side then yes.

The charge lines run up through the floor in the back of my crew cab to the charger, that feeds a 600amp buss bar where my two 280ah...

I ran 1/0 DLO to the dc/dc charger, there is very little voltage drop it pulls about 52 amps and charges about 49 amps. I ran from the...