sijones2010

OK just aheads up, after a couple of days I seem to have hit a load of mqtt data corruption, not sure if it's the data in or the way...

The CAN implementation is a specific variant for Battery/Inverter with specific implementation for each battery manufacturer and the...

Thanks Seagal for correcting me, I had modbus on the brain for ages as was designing a fire detection system integration.

So here we go, a version of the new code that works, it's a bit bloated so over the next few weeks I'll be working on efficiency and...

So... in the background I've been sorting out the new testing release and almost finished it. The victron code has been replaced with...

Lifepo4 batteries are pretty good for charging without loss, so 99% is usually ok, you can just play with it to get the battery SOC...

What's your charge efficiency set in the battery part of the shunt?

The shunt drift should be loss, I.e. soc reports lower than actual. You need to tweak your shunt to reset to 100% on the following...

Currently it wouldn't work, CAN Bus has like a master slave relationship, and your 2nd inverter would respond same time as first - every...

Code isn't reporting any amount of cells, but it is in the spec to be able to inform the inverter, I suspect that your inverter is...

The pylontech protocol switch changes the behaviour of the code. With it enabled it uses the modbus flags to tell the inverter to force...

@ChrisG @ScrotusGobbleBottom Glad you have worked things out, am sorry that I've not been around, I had some illness and life that took...