Turns out most inverter/chargers have this option, but It is not listed in the specs. The trick is to download the manual & look at the actual settings.
I looked at several & decided on a Renogy 48v 3500w unit.
I ordered a Renogy 48v charger/inverter & will check the output when installed to see what the current is & report back. I expect about 85% of the 245w rating due to the age.
One other question, these have 24vdc output so I connected 8 of them in pairs to get 4 ea. 48v outputs in series to...
I have some 13 year old panels that have been exposed to the sun but not connected for several years. Would they be the same as those in constant use? How about if they were stored out of the sun but still the same age?
I have 1960w of solar hooked up an 80a charger & a 12v 120vav inverter with a 12v lifepo4 battery supporting a constant 400w load. It starts dropping the ac voltage below 110v when the batteries drop below 11vdc. It continues to drop the voltage to about 85vac while beeping before finally...
I need to buy 48v charger/inverter support a 400w load that will cut off before ac voltage drops below 110v & cut back on at 1 or 2 vdc greater with no beeping, only switching. It can be preset or user defined, but this speck is not listed that I can find. What is the deal here?
I have not been able to determine dc cut off.cut on voltage on any unit as that is not published & I have been unable to connect with cust support yet.
I was given the 8 solar panels after they were removed from a roof needing replaced. They are 245 w units about 13 years old with a 25 year lifetime. I mounted them on a frame that can be tilted to get optimal sun angle. Obviously I need to upgrade to a 48v inverter as my 12v unit only uses...