v_green57

Okay, cool. I hope that this isn't a regional thing - i.e. rodents from other parts of the country love to chew flue tape... That...

Well, yes, of course conduit would work...IF it's at least 3/4 or larger. Pack rats can and have chewed 1/2 PVC. Running conduit is a...

Since 2004, I've lived part time off grid in a couple trailers in the middle of nowhere in Southern Utah with rattlesnakes and...

https://www.3m.com/3M/en_US/p/d/v101063171/ or https://www.amazon.com/2113NA-High-Temperature-Flue-Tape/dp/B00QSY9H8I

We will know that an AI is truly deserving of the I part of that acronym when it starts refusing the sh!t jobs we organic I's are...

Absolutely yes. Whenever I have to spend time going through content to find something specific, I almost always encounter other bits of...

Yep, you need to "jump start" it. I had this happen once due to letting a battery go below the BMS LVD and then also be below under...

This sounds more like a battery problem. Do you have another you can try? Even a couple 12V car batteries connected in series for a...

Can you draw any current from the battery with a load? You need to determine if this is a CC problem, a BMS problem, a battery problem...

If your battery did indeed discharge to zero, the BMS has probably gone into "protection mode" and disconnected it.. Search the forum or...

I have occasionally used these: https://www.amazon.com/Morris-Products-90612-Mechanical-Number-2-Number-14/dp/B09R92LGPG (the version...

Aha. A completely different thread. Didn't do my research. My bad.

This: "With 800 watts of solar" has never been stated. Without knowing for sure, we are all making somewhat educated guesses. If his...

Take a look at the inexpensive Class D amps on Amazon. A lot of them run directly off of 24VDC. I've used a couple and they are pretty...

Not enough battery, not enough panel, or both of the above. Need enough system capacity to sustain the Float setpoint plus run the...

Got any ferrite cores lying about? Loop the array wiring through them and see what happens.

Try unplugging the temp. sensor and run without it for a while. This will default the temp. reading to 25C/77F.

Huh. Might be a MT-50 specific problem. Have you tried unplugging it, waiting a few minutes, and plugging it back in? I would guess...

I've been using similar pumps for 10+ years to circulate water through some home-made collectors to heat my hot trough. They work fine...

Didn't mean website admin. Meant end user.