Hello, i've a Seplos V3 200A with firmware 0.6 on a 16S lifepo4 battery.
I have some trouble with the SoC reset to 100% when its fully charged on my destination voltage at 55,2V.
Cell overvoltage alarm is set to 3,44v
Battery overvoltage alarm to 55,04v
Charge request voltage is 55,4v
I charge then to this 55,4v, at the BMS, 55,26v measured at this state. I can hold this voltage without any drop below 55,04v about a few hours but no reset is done. Normaly should do a reset after 30 minutes under this conditions already.
Does someone have a idea how this can be solved?
I have some trouble with the SoC reset to 100% when its fully charged on my destination voltage at 55,2V.
Cell overvoltage alarm is set to 3,44v
Battery overvoltage alarm to 55,04v
Charge request voltage is 55,4v
I charge then to this 55,4v, at the BMS, 55,26v measured at this state. I can hold this voltage without any drop below 55,04v about a few hours but no reset is done. Normaly should do a reset after 30 minutes under this conditions already.
Does someone have a idea how this can be solved?