Basic layout questions

[Aphers]

Hi everyone
My system has grown quite messy and it's time to rethink and start again.

I have a long narrow space in which to fit my LFP pack, inverter, and all the busbars etc. So everything has to go in a line (the space is only ~50cm high but 1.5m long).

There's a couple of MPPTs to fit in too but they could go in the locker above, which would help with heat I think.

I'd like to leave space for a second LFP pack at some point.

It's a 12v system with a 3000va inverter so some big cables that need to be kept short.

Basically everything has to go in a line and I'm wondering what's the best way round to do this.

Any suggestions (and pics of examples) would be great because it's a snake's wedding right now...

 

[chrisski]

I have done cardboard cutouts based on dimensions.

Slide out racking could work, but that will take an inch or two off usable height. I looked for weight rated slide outs to build my own, but came up empty.

https://www.amazon.com/gp/aw/d/B007HRQCPQ

I recently used my 24 volt 37 amp converter to charge my battery, and it put out a bit of heat. Enough that I want to install a fan to vent the heat.