I'm looking into converting two of my 12V 100Ah batteries into a single 24V 100Ah battery and I have a few questions about it. First time trying to do something like this so would greatly appreciate your help.
My plan is to open two of my 12V battery cases and pull out the whole assembly, then remove the BMSs, connect the two cell packs into series, and wire everything back to a single 8S JK BMS.
1. I saw a couple of DIY lifepo4 builds and noticed that there were cell terminal busbars of equal length across the battery pack.
With that said, can I connect the two cell packs in series using the cable as shown in the image above?
2. Am I on the right track with this BMS for a 24V 100Ah LiFePO4 battery? Also not sure does it come with the main cables or if I need to buy these too.
My plan is to open two of my 12V battery cases and pull out the whole assembly, then remove the BMSs, connect the two cell packs into series, and wire everything back to a single 8S JK BMS.
1. I saw a couple of DIY lifepo4 builds and noticed that there were cell terminal busbars of equal length across the battery pack.
With that said, can I connect the two cell packs in series using the cable as shown in the image above?
2. Am I on the right track with this BMS for a 24V 100Ah LiFePO4 battery? Also not sure does it come with the main cables or if I need to buy these too.
Last edited: