EG 4 3000ehv 48v new setup flashes "p"

[Wes Butler]

New guy on forum, just finished hooking up my stuff. Here is my set up: 1- EG 4 3000ehv 48v, 2- EG4 rack batteries, no solar or ac in hooked up yet. I do have an ac outlet hooked up. Here is my issue, the little "p" which is suppose to flash when in parallel to signify the master unit is flashing on mine. I try to change setting 28 to SI G from the PAL but it won"t. Any clues? I did try searching for this on the forum. Thanks in advance.

 

[Travis_signaturesolar]

Your inverter has to be in standby mode to change setting 28. Go ahead and turn your batteries then inverter on, go to setting 28, turn off the inverter and once the inverter’s switch is in the off position you will be able to change setting 28 to SIG.

 

[Wes Butler]

Your inverter has to be in standby mode to change setting 28. Go ahead and turn your batteries then inverter on, go to setting 28, turn off the inverter and once the inverter’s switch is in the off position you will be able to change setting 28 to SIG.

Worked just like you said! Thanks for the help!