Phoenix PV
New Member
Recently installed the subject Inverter with a 9 Kw Sunpower solar panel array. Making power just fine until appx 6700 watts achieved and then limited.
Suspecting the third stage of the unit has failed and I can see that there is a red led on (See photo - Just above the green LED). No fault codes.
Does anyone know . . .
1) What the Red LED is indicating (for diagnostics - Guessing NOT good.)?
2) Are there other ways to look at fault codes (Installation manual is all I have)?
3) Any remedies for resolution of the issue?
Appreciate all responses. Most of my experience is on SMA and Schneider inverters.
Best regards,
Mike
Suspecting the third stage of the unit has failed and I can see that there is a red led on (See photo - Just above the green LED). No fault codes.
Does anyone know . . .
1) What the Red LED is indicating (for diagnostics - Guessing NOT good.)?
2) Are there other ways to look at fault codes (Installation manual is all I have)?
3) Any remedies for resolution of the issue?
Appreciate all responses. Most of my experience is on SMA and Schneider inverters.
Best regards,
Mike
Attachments
Last edited: