B Bricktop New Member Joined Nov 16, 2023 Messages 51 Location USA Jan 17, 2024 #1 Had this installed by a company and I went up to look at it and seen there are no ends on racking. Its like that on all the racking ends. Attachments IMG_2241.jpeg 324 KB · Views: 26
Had this installed by a company and I went up to look at it and seen there are no ends on racking. Its like that on all the racking ends.
B BentleyJ Solar Wizard Joined Jan 13, 2022 Messages 2,949 Location Riverside County, CA Jan 17, 2024 #2 Looks like XR10 aluminum rails. Probably easier to just get these end caps at Amazon and install yourself rather than dealing with the sloppy installer. https://www.amazon.com/IronRidge-XR-10-CAP-End-Caps/dp/B07G39X2CJ
Looks like XR10 aluminum rails. Probably easier to just get these end caps at Amazon and install yourself rather than dealing with the sloppy installer. https://www.amazon.com/IronRidge-XR-10-CAP-End-Caps/dp/B07G39X2CJ
B Bricktop New Member Joined Nov 16, 2023 Messages 51 Location USA Jan 17, 2024 #3 I guess I should’ve been clearer in my question. I was concerned nothing is holding the panel down on the ends.
I guess I should’ve been clearer in my question. I was concerned nothing is holding the panel down on the ends.
O Osmethne Solar Enthusiast Joined Aug 18, 2023 Messages 110 Location Salt Lake City Jan 18, 2024 #4 You're correct. I'm guessing they forget to order the end standoffs. Definitely something that needs to be corrected lest a strong wind comes through.
You're correct. I'm guessing they forget to order the end standoffs. Definitely something that needs to be corrected lest a strong wind comes through.
J JLD New Member Joined Jan 8, 2023 Messages 24 Location Idaho falls Idaho Jan 20, 2024 #5 Iron Ridge makes an end clamp that goes underneath panel not seen. Put the hack job with saws all cutting of rails looks bad.
Iron Ridge makes an end clamp that goes underneath panel not seen. Put the hack job with saws all cutting of rails looks bad.