Victron IP43 Error 20 bulk time exceeded

[G8trwood]

After running off battery for a week. I attempted to charge back up with the Victron IP43 phoenix 120-50a charger.
It charged for about an hour and then I got a bulk time exceeded error. If I cycle the power, the error pops back up.
Bulk is set at 8hrs

I put it in power supply mode and it is charging at 50a now. So I can make it work for a bit.

Any setting to reset this error or stop this? I saw several questions posted on the Victron site, but no answers other than disable bulk time. I don’t see a setting to do that.

Thanks!

I could have switched something, not sure.

 

[G8trwood]

I was missing the obvious button to disable the setting.
Very prompt email help from the current connected folks @HighTechLa, to step me through it and a few changes to my settings.

Still don’t know why the error occurred, but computers