buckeyestargazer

Good point LOL. I mistakenly thought that unplugging the switch while "on" would turn the BMS "off" but it doesn't.

Is there a way to factory reset a Daly BMS (this one)? I forgot the settings password so I'm trying to figure out a way to get into the...

The BMS didn't come with any cables, but I have 6awg, 4awg and 2awg silicone wire that I could use, as well as some 1/0 welding wire. I...

I'd like to bump this thread up again. I don't understand why it seems like most instructions and video reviews use 6AWG cables on a...

What I don't like is that the switch LED never turns off. It certainly doesn't draw much, but I don't like the idea of any draw on the...

The bus bars are already slotted, but I am also getting some more robust bus bars for this purpose. Interestingly, I have the BMS...

Here's the one I bought...

I'm adding a JK BMS to a 4S 230AH LiFePO4 battery and I'm wondering about the included on/off switch. This is the first BMS I have that...

Thanks for the info. What do you mean by "can you slot the busses"? If I arrange the cells like in the second pic I posted (post #5)...

Yes that would also work. The easiest way for me to check it out is to draw a quick sketch. I don't have skills to upload a nice...

I have a similar problem with my busbars. I think they are aluminum, but not sure. I could contact the vendor, but other than that I...

The problem with that setup is not having the same resistance with all busses. A little less or more resistance than the original...

The tape is temporary. Part of the reason for wanting to use the hard plastic case is to use some thinner 1/4 plywood for compression...

There is another configuration where you can use just bus bars but the positive and negative will be at the cell on the top left. Bus...

I have no idea what the ampacity of the bus bars are. They came with the cells and there is no indication on them. I have some 1/0...

I am building a 4S 12v 230AH LiFePO4 battery and I'm thinking about putting it in a plastic case. The cells come with metal plates to...

2/0 from shunt to inverter 6AWG from BMS to shunt. The 2 short yellow wires off the shunt to the bussbar are 1AWG I had from the...

Thanks, so dual 6AWG from the BMS to the battery, and 2/0 from the battery to the shunt to the inverter?

I'm adding a JK BD2A8S20P BMS (200A) to a 230AH 4S LiFePO4 battery and want to make sure that I'm using the appropriate size wire from...

I don't need the inverter AC pass through as I already have an automatic transfer switch.