I am having the same issue. It will only discharge if i force discharge or charge if I set a time 00:00 - 23:59 for AC charge. Why are you the only one to see that setting? Why we don't have admin access to our own devices?
Yes. if you look at the the PDF is shows the setup. Grid to main panel to inverter - inverter to critical load. Main panel is powered from grid but not from inverter.
Aaaah, that was it. I didn't realize each CT had a different grid line they needed to be on. I swapped them and "click" the flow reversed. Thanks!!
Still powering off grid but I think you said it takes about 5 minutes to switch to battery?
Lol
No but a whole lot cheaper than the peak charges. X5 the cost.
I was just told to run full charge and discharge for 14 days to setup the batteries.
I was shipped a "parallel kit" with my battery. Which is one positive and one negative and a green rj45. The manual shows 2 red and 2 black from the additional battery and no info on the green cable. Am I missing something? Do I just wire one black and one red from the second battery to the...
Changed that is it immediately clicked a relay and shows the flow going to the grid. That is what I got the first time. That right? Or will that change? Doesn't seem right.
So I should use pins 7 and 8 for communication with solar assistant? And i think i need to set the first battery to PIN 2 and the rest increment from there. And just plug into the #2 battery. This all look correct? Then i would need a different cable with pins 1 and 2 to flash firmware, right?
Discharge is set to 10% and was trying to set charge at the same. If I set the charge to 12% then the discharge will never reach the discharge level. Is that recommended?
I have Solar Assistant and just got my communication cable to connect to the batteries. I assume I now need to set the first battery to DIP 2 and set the inverter to USE? Do I need to set any of the battery setting on the inverter for charging or current? If so, what do I use? I have two EG4...