Recent content by Detritalgeo

Is Battery com's setup?.. Doesn't look like it. Voltages in battery settings are much higher than my BMS controlled parameters..

If the 3KEHV is voltronic components and can support pylontech CAN,... does the 6500EX also?... or is LiA the only CAN protocol for that hardware?

Seems like the cables are in stock on the AOLithium Ebay store now.

Nice. I wish I could see all the metrics per battery.. The Ruixu packs use LIB protocol for my setup and the Solar Assistant driver for that protocol is bare bones.. One value for voltage and current for the entire stack, no temps either.

Maybe I would have to run my 10 405W Longi's in a 10s configuration... would be about 400V 13A max... for one MPPT though. Early morning would be ~180V and typical mid-day would be 360V where I am..

Hmmm, this has me reconsidering the 6k Luxpower now... I have a variant of the Voltronic 6548 with the 250VOC capability. I only really have room for 2 strings of 5 405W Longi Panels and they seem to sit at 90-ish volts until the full sun comes through. This 100v limit makes me think the...

I just saw Seplos uses the same connector on some of their kits... Maybe thats an option if they sell parts.

FSP connectors from Futronics. part number: FSP800160TZ-25U1A1K 2384 125A rated, up to 25 mm2 cable (~3 AWG) Something like this... https://www.metabee.com/waterproof-energy-storage-connector-right-angle-125a-orange-25mm2-unshielded-cable-z-key-id20220600044.html

The SOC may deviate if you ever have a load of less than 0.5A per battery.. Any time less than that will not be recorded as consumption by the BMS. So if you left the inverter on idle for a week, without solar input, the batteries would die with 99% SOC indicated.

You could order from ca.aolithium.com and get them routed back to US via forwarder... just an option..

They also ship with 25mm2 (3 AWG) cable... You could always replace a few of the connections with generic lug-type parts..

They are made by Futronics, (http://futronicsconnector.com/list_14/81.html).. They seem to be selling them here: https://www.metabee.com/waterproof-energy-storage-connector-right-angle-125a-orange-25mm2-unshielded-cable-z-key-id20220600044.html

Which EG4 model are you asking about?

Just speculation, but maybe the current version of the app will only read and display those metrics if the pack and protocol is EG4.

Almost ordered but really my system is hobbiest level and I only need 1500-2000W top up slowly in the winter so decided this was overkill (wont have a generator).. I just picked up a 1500W 60V power supply for $250 to top up when needed.